SubscribeBesides Cavotec Fladung's activities in the aircraft support industry they also offer a comprehensive range of physical security systems.
Rising Bollard System
The rising bollard system is a safety system comprising of barrier stops that can be raised or lowered on command so as to control the entry and exit of vehicles to and from a certain place.
The rising bollard system consists of several individual pillars that are placed inside a concrete trough. Each individual pillar is operated electro-hydraulically.
At specific locations, there is a storage assembly, which is connected to the inlet side of the hydraulic system. This ensures that the assembly moves the stop under pre-tensioning pressure in the storage assembly, faster than stops that are only moved by a hydraulic system.
These storage assemblies are also equipped with a battery cushion for control voltage in the electrical system. Two strokes can be executed even after the power is cut off.
Optionally, all the shaft structures can be equipped with a heating system, which enables problem-free operation in wintertime. The shaft area of the control system is also equipped with a ventilation system, which ensures optimum air-conditioning.
The covers of the stops and the shaft are trough-shaped. These troughs are paved with the same paving material as the adjoining road. The traffic-carrying capacity of all the shafts and the bollards corresponds to the loads as per SLW 60.
When lowered, the stops are flush with the road paving. When raised, they are adjusted to the height of the adjacent fixed stops. Both the stops as well as the support foundation are statically designed for an impact load of 120KN.
Speed-Stop
The Cavotec Fladung Speed-Stop Street Barrier consists of 3 or more individual barriers which, when raised, completely secure entry and exit points from any type of traffic.
The speed stop is equipped with a hydraulic-power storage system housed along with an electrical control system in one single device cabinet. The system activates within 2 seconds making it the fastest security system in the world.
In the deactivated condition, the barriers of the underfloor mounting unit are flush with the road and are fitted with chequered plates. When activated, the barriers swing up by 90° so that they are perpendicular to the roadway at intervals of 825 mm.
The barriers swing against a fixed stop, and are blocked in the opposite direction by a cylinder. This locking prevents the barriers from sinking in the swung-out condition even under an external vertical or horizontal load.
The entire underfloor mounting unit consists of a hot-dip galvanised steel frame construction and is statically constructed in accordance with the expected load.
All rotating parts have been supplied with a permanent lubricant dispenser. The bearings are made of high quality bearing metal and the shafts are made of stainless steel. The barriers are operated by a high performance cylinder with end-of-travel damping. If the pump fails, it is possible to operate the speed stop several times using the pressure accumulator. In emergencies, the speed stop can also be operated with hand pumps.
Entry Control
Cavotec Fladung's Entry-Control system is a versatile system developed to safely monitor entry and exit of vehicles.
The system has a short installation time. The profile of the unit is low which makes it possible to install the unit in places where no other entry-control unit could normally be installed.
Because of its innovative design the unit can be adapted to any road surface and width. When activated the Entry Control system can withstand very high impacts without deformation.
Mobile street barrier
The mobile street barrier is Cavotec Fladung's answer to today's security needs. The unit can be setup in a couple of hours and provides complete control of incoming and outgoing traffic.
Due to its relatively small dimensions the mobile street barrier is the ultimate choice for installations where time, space and mobility are at a premium.
